Metalworking tool set 3, punch tools (22 tools), inlay size 450x500 mm

Tool inlays for drawers: Metalworking 3 – punch tools, set comprising 22 tools in two-tone (black/grey) foam inlay of dimensions 450x500mm,
suitable for drawers with a panel height of at least 100mm.

8 Drift punches:
- Fully hardened and annealed
- Inductively annealed head
- Ground and oiled working surface
- Chromium-molybdenum-vanadium 45CrMoV7/1.2328
- Manufactured in compliance with DIN 6458

11 Pin punches:
- Fully hardened and annealed
- Inductively annealed head
- Ground and oiled working surface
- Chromium-vanadium 59CrV4/1.2242
- Manufactured in compliance with DIN 6450

3 Hammers:
Plastic ball hammer
- Head held in place with cast zinc
- Interchangeable heads made of impact-resistant cellulose acetate
- Real ash handle, DIN 53505, Shore D 65

Recoilless nylon soft-face hammer
- Particularly suitable for hammering into positions
- For non-rebounding dead blows without any loss of hammer force but non-harmful to impacted materials
- Tough steel centre bar with stud and collar for attachment of heads
- Weight precisely determined by means of steel shot inside (inertial principle)
- Nylon heads, interchangeable
- Hickory handle, DIN 53505, Shore D 73

Rubber hammer
- With 2 flat striking faces
- Real ash handle, interchangeable heads
- DIN 5128-90, Shore A 90